Centrala Termica Ariston Microtec 23 Mffi Manual

Aug 23, 2013 Ariston t2 23 mffi manual de utilizare MICROTEC 23MFFI si. Centrale termice Oct 18, 2009 Centrala ta este model Microgenus 23 mffi si este.

• Servicing Instructions Type C Boilers G.C.N: 47-116-14 47-116-15 LEAVE THESE INSTRUCTIONS WITH THE END-USER Country of destination: GB. • TABLE OF CONTENTS SERVICING INSTRUCTIONS EPLACEMENT OF ARTS ENERAL CCESS - Removing the front panel - Removing the sealed chamber frontal cover - Removing the side panels CCESS TO THE OMBUSTION HAMBER - Removing the combustion cover - Removing the burner and jets - Removing the electrodes - Removing the main heat exchanger - Removing the air pressure switch. The control panel moves downward and when pulled forward, SERVICING INSTRUCTIONS rotates on two lateral hinges; the panel stays in a semi- horizontal position, which allows access to the inner parts of To ensure efficient safe operation, it is recommended that the the boiler (F. • Removing the sealed chamber frontal cover Removing the side panels 1. Remove the screws “C” (F. Remove the four screws “D” for each side panel (F.1.8); 2.

Lift the sealed chamber frontal cover from the locating pins 2. • CCESS TO THE OMBUSTION HAMBER Removing the combustion cover 1. Remove the screws “E” (F. Lift off the combustion cover.

1. Lo strano mondo dei materiali metallici download adobe. 12 78 eps Removing the electrodes Before carrying out this procedure, unscrew and slide the burner forward (see previous section). Remove screw “H” (F. 1.15); Removing the main heat exchanger 4.

Gently slide the electrode downward (F. Acca software certus crack. Drain the boiler of water; 2.

Release the overheat thermostat sensor “I” (F. Release the two connection nuts “J” connecting the exchanger to the flow and return pipes (F. • Removing the air pressure switch Removing the fan 1. Disconnect the electrical connections “K” and silicon pipes 1. Disconnect electrical connections “N” and silicon pipes “L” from their connection points (F. 1.20); “O” (F.1.23); 2.

Remove screws “M” on the top of the sealed chamber 2. • ERVICING AND EMOVAL OF THE ALVE Setting the minimum and the maximum power of the boiler Setting the gas pressures 1. Check that the supply pressure to the gas valve is a minimum of 20 mbar for natural gas. To do this, remove the screw “A”.

Fit the pipe of the pressure gauge to the pressure connection of the gas valve “B”. • Regulating the heating power for natural gas (G20) model 23 model 27 CG007A Regulating the heating power for butane gas (G30) model 23 model 27 CG008A Regulating the heating power for propane gas (G31) model 23 model 27 CG009A “A” ABLE 2.01 Kg/h 2.00 Kg/h. • Removing the spark generator 1. Disconnect ignition leads “T” by pulling upward. Remove the screw “V” (F. Remove the spark generator (F. 61.eps Soft-light Max Heating Adjustment Adjustment VR015A.eps.